Skip to content
Afterburn EventsDJ & Wedding Sound

Sound Equipment

Powering Event Sound and Lighting with Generators

For outdoor sound, use a silent or super-silent inverter or diesel generator sized for your total load plus a healthy margin, placed well away from guests, and distributed through RCD-protected boards. Audio and LED lighting need stable voltage and frequency, which is why inverter or well-regulated sets are preferred.

Last reviewed:

Work out your load first

Add up the rated power draw of every item that will run from the generator — speakers, DJ equipment, lighting, catering — then add a margin. Speaker power ratings describe amplifier capability, not typical draw, so check the mains rating label or manual.

ItemWhere to find the figure
Active speakers and subsMains rating on the rear panel or manual
LED lightingManual; usually low per fixture
Catering kit (urns, fridges)Often the largest loads — plan separately

Inverter vs standard generators

Inverter generators produce a cleaner, more stable output and adjust engine speed to load, which makes them quieter. Large diesel sets used by marquee companies are typically well regulated too. Small, cheap open-frame generators can cause hum, glitches and damage to sensitive electronics.

Connections and distribution

  • 16A (blue CEEform, 230V) and 32A connectors are standard on event distribution.
  • Use a distribution board with RCD protection for outlets.
  • Keep audio and catering on separate circuits where possible.
  • Run cables away from walkways or under cable ramps.

Earthing and ground loops

Generator earthing should be arranged by a competent person following the manufacturer's instructions and BS 7909 guidance for temporary event power. Hum from ground loops is best solved with balanced cabling and isolation devices on audio lines — never by removing a safety earth.

Placement and noise

Place generators downwind and as far from the marquee as cable lengths and voltage drop allow, with fuel stored safely. Check whether the venue or local authority has noise or running-time conditions.

Planning a marquee wedding?

Use the reception audio checklist